We coat garage, basement and patio floors throughout Peterson with the system built for northern Utah: diamond grinding, polyurea repair, full flake and a UV-stable polyaspartic topcoat. Rural shop floors here handle tractors, trailers and firewood in a climate that freezes and thaws hard all winter.
Peterson sits along the old road through Morgan Valley about seven miles below Morgan, with Thurston Peak towering to the west. The general store and its post office were the center of the settlement for over a century, and the ground here is still mostly hay and pasture.
SwiftHand Concrete Coatings is the coatings arm of SwiftHand Painting, an owner-run Salt Lake County company, and Peterson is squarely inside our everyday service area — not a place we drive to twice a year. The same crew that grinds and coats in Mountain Green and Morgan is the crew that shows up on your driveway.


Peterson sits at about 4,885 feet in Morgan Valley below Thurston Peak, the highest point in the county, so nights are cold, snow lingers and cold air drains down the canyons onto the valley floor. Freeze-thaw runs harder here than on the Wasatch Front.
A small unincorporated farming settlement of older valley homes and farmsteads mixed with newer rural houses on acreage. Detached shops and outbuildings are more common here than attached suburban garages.
Bench homes in Peterson get more snow than the valley below, more canyon wind, and steeper driveways that get salted harder. That means more brine tracked into the garage and more freeze-thaw cycling on the slab. It's exactly the environment a polyurea/polyaspartic system is built for — and the reason we never top a bench garage with epoxy that would yellow in the extra sun.
Every floor gets diamond grinding, polyurea repair, a moisture test and a UV-stable polyaspartic topcoat.
Garage floors ground, repaired and coated with a UV-stable topcoat and a 15-Year warranty.
Learn more →Basement floors for gyms, playrooms, storage and finished spaces — warm micro-flake or metallic.
Learn more →Outdoor concrete coated with a slip-resistant, freeze-thaw-tolerant polyaspartic system.
Learn more →Hand-poured metallics and heavy-duty quartz for showpiece and hard-use floors.
Learn more →Commercial coatings and polished concrete with striping, cove base and fast return to service.
Learn more →Finish the whole garage: door repaint, slatwall, cabinets and overhead racks.
Learn more →From Peterson Creek to Thurston Peak, we've got Peterson covered — and if your street isn't listed, it's still in our everyday service area.
We plan Peterson jobs around bench weather: a dry slab in the morning, heat in winter, and a two-day schedule if the garage is unheated and the forecast is below about 20°F.
Instant quote online or a free consultation at your Peterson home.
Dust-controlled; never acid etch.
Polyurea mender; vapor test on every slab.
Polyurea base, full flake, UV-stable polyaspartic.
Crew lead and you, before we leave.
Most Peterson garages land between $1,800 and $4,500 installed — roughly $5–$9 per square foot for a full-flake polyaspartic system, with slab repair, old-coating removal and premium finishes moving the number. Basements often price lower per foot; metallics and quartz price higher. The instant quote builds a written price for your actual square footage in about five minutes.
Answer a few questions about the space — size, condition, the finish you like — and our instant quote tool builds a written price on the spot. It takes four to five minutes, not sixty seconds, because an accurate number beats a fast one. Prefer a person? Book a free consultation and we'll measure in person.
Trouble loading? Open the instant quote in a new tab.
Most Peterson garages run $1,800–$4,500 installed for a full-flake polyaspartic floor — about $5–$9 per square foot depending on size, slab condition and finish. Get an instant written price or read the cost guide.
Yes. Polyaspartic cures near freezing and we heat the garage while we work. Most winter installs in Peterson are still one day on site.
For a garage that sees Utah salt, sun and hot tires, yes: it doesn't yellow, cures in the cold, flexes with the slab and resists hot-tire pickup. We install both and price them the same. Full comparison.
A properly ground and installed polyaspartic floor should last 15–20+ years here, and it carries our 15-Year transferable warranty against peeling, delamination, hot-tire pickup and yellowing. Warranty terms.
All of it — garages, basements, patios, porches, pool decks, steps, shops and commercial floors. Rural shop floors here handle tractors, trailers and firewood in a climate that freezes and thaws hard all winter.
Instant online price in about five minutes, or a free consultation at your home. Call or text 801-895-3794.
